3D working sweet dispenser

This sweet dispenser actually works by turning the handle on the front, it works by using gears that I created.

When the handle is turned the sweets fall down the shoot and out the other end.

This can be re-filled very easily by undoing the bow on the top 'dome' section.

It measures approximately: 18cm high x 15cm square.

You will need:

4 sheets of A4 card for the whole of the base including the workings on the inside

2 sheets of A4 or 1 sheet of 12x12 acetate for the 'dome'

2 sheets of A4 or 1 sheet of 12x12 pattern paper to decorate

Full word and picture instructions are included in your download.