3D Ferris Wheel/Big Wheel - gsd and svg

Everyone loves a fun fair and one of the more memorable rides is the Ferris Wheel. It scared the living daylights out of me when I was little and it still does now, but this one is super cute and not at all scary.

To make this up you will need some BBQ Skewers cut down to 9cm and some 8mm beads with a hole large enough to fit your skewer through. I also recommend wet glue as this gives a better hold and you have a little bit of play time before it dries.

You will need 8 sheets of A4 card to complete this 3d cutting file.

I used:

2 sheets of blue and a sheet of red for the base sections.

1 sheet of orange and 1 sheet of green for the booth and the fence .

1 sheet of purple for the ferris wheel seats.

1 sheet of purple for the ferris wheel side supports

2 sheets of pink for the side of the wheel sections.

Approximate overall measurements are: 26cm in length x 19cm in depth x 21cm in height.

There are no instructions with this one but there are guidelines within the files.